Performance Accessories 2" body lift
Performance Accessories 2" body lift
PAGE 2
After lifting the cab, I checked all clearances, the brake line on the
drivers side, on top of the frame, had popped out from it's retaining clip.
I spread the coil of brake line below the ABS module, and re-attached the clip
Next I had to install the lower fan shroud bracket(pic 1), which holds the bottom of the
lower fan shroud in place. The upper fan shroud attached to the original mounting
place on the top of the radiator support, and the spacers (pic 2) installed between
the upper and lower halves connecting them. Then the brackets for the oil filter
adapter (pic 3), which is necessary for trucks with an oil cooler, the hoses are routed(br>
above the oil filter adapter and would interfere with the lower fan shroud if the
brackets aren't used.
Next I lifted the bed, first driver side, than passenger side. I installed the filler pipe extension
and installed the filler pipe to the tank and bed (pic 1).
The tailpipe stuck down WAY too low, so I hacked off a 5-6" piece(pic 2 and 3).
Before and after hacking off the tailpipe
And finally I installed Gap Guards on the rear, the front stock guards were ok
and covered up the lift by themselves, but the rear was embarassing
Page 1
Back to the Tech page
Back to the Main page